Okay folks. A newbie to the forum here. I used to ask hardware questions in the Kenwood forum but the moderator of that forum shut it down unexpectedly and does not plan to revive it. So, here I am in the GPS forum asking about hardware issues.
I purchased a used DNX570HD nav receiver that is stuck in a boot loop. I have seen similar posts here about this condition but wanted to make sure to address the DNX570. For those of you that experienced this issue, did you do a firmware update? If so, how if the unit is in boot loop? If not, does anyone know what the hardware solution is? I read in some places that the ROM IC can be replaced (From PacParts IC loc# IC101 (Power Amp). If this was addressed someplace else in this forum, please direct me to the right place. Thanks so much.
I purchased a used DNX570HD nav receiver that is stuck in a boot loop. I have seen similar posts here about this condition but wanted to make sure to address the DNX570. For those of you that experienced this issue, did you do a firmware update? If so, how if the unit is in boot loop? If not, does anyone know what the hardware solution is? I read in some places that the ROM IC can be replaced (From PacParts IC loc# IC101 (Power Amp). If this was addressed someplace else in this forum, please direct me to the right place. Thanks so much.