Hi everyone, i'm trying to unbrick a nüvi 760, but I can't get it to flash the cure firmware.
With Cure3 I've made the cure firmware out of everyone on the list here:
![MXeLcve]( "MXeLcve")
After making the cure, i put the unit in pre-boot mode
When it gets detected, open the updater, select the unit and click ok
Update starts, but depending on wich version I use, gives me an error of memory (4.80 an higher) or finishes ok (anyone lower than 4.80) but still doesn't boot to mass storage mode, just keeps restarting. Shows the garmin logo, powers off, and powers on again. If i run g7towin tells me that software version is 4.70 everytime after updater tells me that finished ok (it should be the one i flash, not always 4.70), thats why i'm guessing that the updater never flashes the unit
- Tryied in 3 different PC (windows XP and 10)
- Tryied with 2 different cables
- Tryied with all the firmwares i could find
- Tryied with QuickCure file, didn't worked either
No one worked, any help you can give me it would be great. Thanks in advance!
With Cure3 I've made the cure firmware out of everyone on the list here:
After making the cure, i put the unit in pre-boot mode
When it gets detected, open the updater, select the unit and click ok
Update starts, but depending on wich version I use, gives me an error of memory (4.80 an higher) or finishes ok (anyone lower than 4.80) but still doesn't boot to mass storage mode, just keeps restarting. Shows the garmin logo, powers off, and powers on again. If i run g7towin tells me that software version is 4.70 everytime after updater tells me that finished ok (it should be the one i flash, not always 4.70), thats why i'm guessing that the updater never flashes the unit
- Tryied in 3 different PC (windows XP and 10)
- Tryied with 2 different cables
- Tryied with all the firmwares i could find
- Tryied with QuickCure file, didn't worked either
No one worked, any help you can give me it would be great. Thanks in advance!